In preparation for Open Make: Tools, I tried a Tool Dissection yesterday. In the Learning Studio, there are a couple of broken tools that we collected in the past, so I chose this Makita hand drill for my first time tool dissecting experiment.
I prepared some tools to use for dissection, at this point, I didn't know what tools would be actually needed for this dissection.
Anyway, I opened the plastic cover.
There I found batteries (in the brown papers), a big motor, gears, some rings, a chuck, a switch, a charger, a few wires, etc..
I could easily disassemble everything EXCEPT this chuck. It got rings and gears, and I had no clue where to try taking them apart. Everything seemed to be very rigid. After consulting with Antonio and Tim, I could find a big screw hiding inside in the middle of the chuck jaws, then I unscrewed it.
Better lighting will be definitely needed for this activity. Also, to me, a small flash light was helpful to find the hiding screw.
After unscrewing the hiding screw, I basically hammered each part out. For that, a vise, a big fat screw driver and a little knowledge of principle of leverage were very helpful.
Look at the three chuck jaws (right photo)!
It was really fun to get to know that almost anything can be taken apart even if they don't look like disassemblable.
These are all the parts from the hand drill. Beautiful!
Ok, so, dissecting was fun, but where could we go from here?
What would you do after dissecting tools?
.
.
.
.
... this is my first attempt to make an art piece from the parts taken apart.
You can also make a cute badge like this using some parts.
Or, you can make a cool necklace like this out of a reversing switch!
What would you make out of these parts?
We will continue exploring, messing around, and playing with the idea of dissection. Stay tuned for updates!