Skip to main content

Filling in engraving on wood!

Ryoko Ryoko
October 8, 2014
Calculating...
Filling in engraving on wood!

We love laser engraving!
We've been laser engraving on wood and plastics and they have been great when we make signs/signage in the Tinkering Studio. Lately I've been experimenting with filling some paint in engraving so that the letters (or designs) will have additional uniqueness rather than just having scorched or burned color. And here is the method that I've found so far that seems working well, and want to share it with you!

photo 1(6)
To seal the wood surface, apply varnish (I used "Stays Clear" from Benjamin Moore) and let it dry. Mask with blue masking tape.

photo 2(6)
Laser engrave! This part requires some adjustment with the laser cutter setting, especially the depth of the engraved gutter is important. If it came out shallow, you can engrave the same piece one more time (but don't move the piece at all!) and make the gutter deeper enough to fill the paint in it.

photo 4(3)
Apply the same varnish in the gutter. (I find this process is skip-able. Sometime, your tape gets too wet because of the varnish and won't work well later when you try filling the paint.) Let it dry well.

photo 1(7)
Fill the engraving with paint! I used BreakThrough paint with a small brush (Q-tip also works well). BreakThrough is thick and quick to dry. I think any kind of acrylic paint would work. Let it dry.

photo 2(7)
Carefully peel the masking tape. You might see the paint is bleeding.

photo 4(4)
Some bleeding is ok! You can sand the surface with finer grit sandpaper (I did 150 first then 220), and you will get the clean outlines.

photo(85)
This is how it turned out!

photo(87)
The same technique could be used for more detailed drawings like this. White masking tape also worked well.
Just be careful not to make any gap between the tape (Avoid overlapping the tape, because that will make the gutter depth different).

photo(86)
I like how it turned out. It definitely takes more time than simple engraving, but gives a little more uniqueness to your design and make it less laser-cut looking. You can try it with different paint colors on various kinds of wood and find your favorite combinations!